Your Search for "burlap garland" results:
Burlap Garland Banner
Cut 10” lengths of the burlap garland to create the sections of the banner. Cut and lay out enough pieces to reach your desired length. Cut one end of all burlap sections into a “V” shape as shown. Don’t worry about the burlap unraveling, as you will trim again after you paint to get a […]
Frayed Burlap Pumpkins
Use foam cutter to remove approx—5 1/2″ diameter circle off top and bottom of 10″ ball. On top, scoop out area, going about 2″ deep. Use foam cutter to smooth any edges so that foam goes smoothly from outside into bowl-like area. Inside the center of bowl area, carve out a 1″ diameter, 1″ deep […]
Fabric & Burlap Americana Decor
To cover foam stars with navy fabric, use a marker to lightly trace around the star on the back side of the fabric. Use floral shears to cut out 1/4″ outside marker line. Apply glue stick to star and center on the wrong side of fabric star. Clip corners, pull up, and glue each 1/4″ […]
Glass & Burlap Decor
Use foam cutter to trim foam brick to 2 3/4″ x 2 3/4″ x 7 7/8″. Measure and cut 4″ square from burlap garland and set aside for flower. Starting at the bottom, wrap burlap around brick, slightly overlapping with each wrap. Allow approx. 3″ of burlap to extend beyond the top edge of the […]
Christmas Burlap Trees
To create the large tree, use the Foam Cutter or serrated knife to cut off 10.5” from the top of the 24” cone. Save this piece for the top of the tree. Cut 6” off the top of the 18” cone. Cut 6” off the top of the 15” tree. Set aside the two 6” […]
Autumn Twig Decor
1. Stack one foam block on top of other and hot glue. In well-ventilated, newspaper-covered area, spray foam block unit on all sides with two coats Terra Cotta spray color. To slightly darken, lightly spray block unit and branch with Glossy Wood Tone. Let dry. 2. Use wire cutter to cut and trim branch as […]
Chevron Foam Pumpkins
Glue two of the cubes together, one on top of the other, to create the taller cube pumpkin. Use the foam cutter to cut 4″ off the 12″ end of the foam sheet to create a flat, square pumpkin shape. Set aside the 4″ x12″ piece to attach to the stand later. Cut lengths of […]
Succulent Wall Hanging
Pin the end of the burlap garland to the narrow end of the cone letting about 1” hang over the bottom. Wrap the burlap around the cone to the top wide end covering the sides completely. Pin the burlap in place at the back of the cone, but don’t cut the burlap at this point. […]
Bamboo Accent
Hot glue together two foam blocks to create one (approx.) 4″ x 4″ x 12″ block. Set block vertically on end. Wrap placemat around it. (Note: Placemat should align with table at bottom and extend a couple inches above block.) Then check the fit to see how to secure placemat ends. (Note: Depending on fit, […]
Icy Winter Arrangement
Place foam half ball, flat side up in metal bucket, using glue gun to attach rounded surface to bottom. Press in place until firmly set. Use floral shears to cut 3″ x 1 yd. cream-colored fabric. Fray 1/2″ on both long edges by pulling and removing threads, one at a time. Wrap around middle of […]
Subscribe
