Your Search for "" results:
Winter Wedding Table Arrangement
Use foam cutter to trim dry foam sheet to fit inside tray. Use glue gun to attach to bottom. Press in place until firmly set. Depending on weight of floral wire, use Floral Shears or Wire Cutter to trim floral stems to approximately 1-1/ 2″ lengths, as you go along. Start with one large Daisy […]
Jute-Wrapped Cone Sconce
The Foam Cone should be painted so that any spaces between Jute Twine wraps don’t show through as white. Also, the wide end will be left uncovered so that florals can be inserted and that would look better not being white. So, in a well-ventilated, newspaper-covered area (inside box) spray Foam Cone Antique Gold. While […]
Autumn Twig Decor
1. Stack one foam block on top of other and hot glue. In well-ventilated, newspaper-covered area, spray foam block unit on all sides with two coats Terra Cotta spray color. To slightly darken, lightly spray block unit and branch with Glossy Wood Tone. Let dry. 2. Use wire cutter to cut and trim branch as […]
Loopy Burlap Ribbon Wreath
1. To create a high-low look, the foam wreath is covered in large and small loops of burlap ribbon. Use a ruler and floral shears to measure and cut the following lengths of 2 1/2″ wide natural burlap ribbon: forty 6″, twenty-five 8″, and thirty 10″. (Note: Keep lengths separated into three groups.) 2. With […]
Fall Floral Sconces
Use foam cutter to cut foam balls in half. Set both halves, cut side down, in a well-ventilated, newspaper-covered area (inside box) — spray ball halves with spray adhesive. Remove from box and cover with Spanish Moss. Apply hot glue to the top of the rim on each candle sconce and set the ball half’s […]
Firecracker Decor
Measure and use Foam Cutter to cut Foam Rod into three lengths: 12″, 10″ and 8″. Use the remainder of the Rod as “sandpaper” and rub the cut edges of each length to smooth. Wrap red chevron paper around 12″ long Rod and mark, allowing for 1/2″ overlap. Use a paper trimmer to cut paper. […]
Mesh Loop Flower
Use Floral Shears to cut sixteen 10″ lengths of Purple Decorative Mesh. With one length, make a petal by folding both long (raw) edges to the middle of the length. Then fold in half with short ends meeting. To taper open end of petal, fold over both sides and secure with floral pin (angled in) […]
Mesh Gift Centerpiece
To cover the top and bottom of the Block so that it’s white under Mesh, use Floral Shears to cut twelve 8 1/2″ lengths of white ribbon. Generously apply glue stick to the top of the Block. Attach six ribbons lengths, side-by-side, overlapping 1/4″. (Allow cut ends to extend slightly over Block edges.) Hot glue […]
Bronze Dinner Centerpiece
Use foam cutter to trim foam brick to fit inside container. Hot glue on bottom to hold. Use wire cutter to cut apart and separate flowers and leaf stems from one Aster Mum bouquet, leaving stems as long as possible. (Wait to cut apart other bouquet until you’re arranging and can see how many more […]
Mesh Basket Bows
Use Wire Cutter to cut 8″ length Floral Wire. Use Floral Shears to cut two 1 1/2 yd. lengths Decorative Mesh. Horizontally place one Mesh length on the table. Make bow loops by bringing ends in so one crosses the other just below the middle of the Mesh length. Grasp crossed area and middle of […]
Funky Chunky Florals
For Floral Arrangement: Prepare project bricks to be sprayed by inserting toothpicks into their ends and setting the other ends into the scrap foam. Place them about 1″ apart in rows. (Ideally, divide bricks into four groups, with each group being placed on its own scrap foam.) In a well-ventilated, newspaper-covered area, spray all four […]
Welcome Baby Arrangement
Put handle to the front of the bucket. Place Foam Block onto the rim of the bucket with the largest side of the block to the front. Use a pencil to mark where the block needs to be trimmed to fit. (Note: If bucket tapers, draw a pencil line to taper block on both sides.) […]
Subscribe
