Supplies
- FloraCraft®
-
- 6” Straw Wreath
- 3” Wood Number Pick
- Faux Dusty Miller Stems
- Faux Queen Anne’s Lace
- Acrylic Paint - Black
Tools
- Low-Temp Glue Gun
- Wire Cutters
- Scissors
- Paint Brush
Instructions
- Cut the pick attached to the table number down to 1”. From the remaining pick, cut a 2” piece to use as the kickstand, for the wreath to stand up on the table.
- Paint the table number black (or color of choice) and let it dry.
- Apply glue to the 1” pick and insert it into the center of the wreath, so the number stands upright.
- Cut the Dusty miller into smaller pieces. Glue them to the front of the wreath below the table number pick. Arrange a few pieces trail slightly up both the right and left sides for a soft, natural look.
- Glue Queen Anne’s lace into the center of the Dusty Miller for a focal point.
- Add in a few sprigs of Dusty Miller and a small piece of Queen Anne’s Lace and glue them to the top left side of the wreath, as pictured.
- Glue the 2” kickstand pick at an angle to the back of the wreath to act as a kickstand, allowing the wreath to stand upright on the table.
"*" indicates required fields