Your Search for "foam tool" results:
Felt Tucked Cupcake Ornaments
Press the foam ball firmly on the table to create a flat spot on one side of the ball. Glue the flat side into the bottom of the cupcake liner. If the liners are thin, glue two or three together, so they are less likely to get wrinkled. Cut 2” circles from the felt. You […]
Fall Felt Wreath
To make pattern for wreath sections, trace Foam Beveled Ring onto newspaper and cut out. Fold paper circle in half and then half again (creating fourths). While still folded, fold circle into thirds. Unfold. (There should be twelve even sections between fold lines.) Place pattern on top of Ring. For guidelines, use permanent fine line […]
Patriotic Wreath
1. Start by marking out your pattern on the wreath form using the black marker. Mark each section with a “B” for blue, “W” for white, and “R” for red. The blue section should be approximately ¼ of the wreath, as shown. The red and white sections are approximately 4” each and alternate around the […]
Golden Floral Wreath & Arrangement
Centerpiece Glue the FloraCraft® DryFōM® brick into the center of the vase. Combine green and amber gems then pour into the vase to hide the sides of the foam. Use floral pins to attach the grapes to the side of the foam brick allowing them to hang over the edge of the vase. Use low-temp […]
Haunted Mausoleum
Starting the bottom layer and structure: Glue five bricks together end to end for wall 1; repeat this to create walls 2, 3, and 4. Glue the end bricks from walls 1 and 2 together to form a corner. Repeat to add walls 3 and 4. This completes the square bottom layer. Repeat these steps […]
Subscribe
