Sorbet Mesh Wreath

Skill Level: Beginner

Write a Review

| More

Supplies

  • FloraCraft® Extruded Foam Wreath: 10"
  • Design It: Simple Style® 10" Decorative Mesh: Orange Ombre
  • Floral pins
  • Scissors
  • Ruler

Instructions

  1. Gather the end of the mesh together tightly. Pin the gathered end to the inside edge of the wreath. Measure out 8″ and gather the mesh together again at this point. Loop the mesh and pin the gathered portion 2″ apart from the first pin. Continue measuring, looping and pinning on around the inside edge of the wreath. Cut the mesh, gather the end and pin again.
  2. Gather and pin the end of the mesh to the face of the wreath. Measure out 10″ and gather again. Make a loop and pin this gathered section to the wreath 2″ apart from the first pin. Continue measuring, looping and pinning the mesh on around the face of the wreath to point of start. Cut the mesh, gather the end and pin in place.
  3. Gather and pin the end of the mesh to the outside edge of the wreath. Measure out 10″ and gather again. Make a loop and pin this gathered portion to the wreath 2″ apart from the first pin. Continue measuring, looping and pinning around the outside edge of the wreath. Secure the mesh.

Leave a review or ask a question