Your Search for "shears" results:
Burlap Ribbon Snowman
Use Foam Cutter to trim 2″ diameter circle off top and bottom of 6″ Ball and just off bottom of 4″ Ball. Use a spoon to scoop out approx. 1/2″ deep from each circled area. (This will give overlapped burlap ends a place to go and a flatter surface for the base and gluing Balls […]
Bamboo Accent
Hot glue together two foam blocks to create one (approx.) 4″ x 4″ x 12″ block. Set block vertically on end. Wrap placemat around it. (Note: Placemat should align with table at bottom and extend a couple inches above block.) Then check the fit to see how to secure placemat ends. (Note: Depending on fit, […]
Winter Tree Tablescape
Pour some Winter Snow onto a paper plate. In a well-ventilated, newspaper-covered area (inside a cardboard box), spray all around the sides of one Foam Cone with spray adhesive. Holding Cone at top and bottom, roll Cone into Snow on a plate. Press firmly enough to adhere. Place Cone in spraying box and repeat process […]
Carved Textured Pumpkin
To evenly divide the ball into six equal sections, place one rubber band vertically around the ball. Vertically place second and third rubber bands onto the ball so that all rubber bands cross each other at the top and bottom center. Adjust rubber bands to make six equal sections. Use a marker to trace along […]
Icy Winter Arrangement
Place foam half ball, flat side up in metal bucket, using glue gun to attach rounded surface to bottom. Press in place until firmly set. Use floral shears to cut 3″ x 1 yd. cream-colored fabric. Fray 1/2″ on both long edges by pulling and removing threads, one at a time. Wrap around middle of […]
Fabric Wreath
Note: If using 1 ½” wide strips, follow instructions as written. If using 2 ½” wide strips, simply fold strips in half lengthwise as you wrap around the wreath and tie for fuller tails – or use a rotary cutter to cut 2 ½” strips lengthwise, cutting half as many. (Note: A few extra strips […]